3Hp Plastic Outside Pool Swimming Pool Water Pump Swimming Pool
Pump 3hp
| Model | Voltage | HZ | Power(KW) | Power(HP) | Hmax(m) | Qmax(m³/h) | Port Size(inch/mm) |
| FL-150 | 220V-240V | 50/60 | 1.1 | 1.5 | 18 | 30 | 2.0/63 |
| FL-200 | 220V-240V | 50/60 | 1.5 | 2 | 19 | 35 | 2.0/63 |
| FL-300 | 220V-240V | 50/60 | 2.2 | 3 | 20 | 38 | 2.0/63 |
| FL-350 | 220V-240V | 50/60 | 2.6 | 3.5 | 21 | 40 | 2.0/63 |
| FL-400 | 380V | 50/60 | 3 | 4 | 22 | 48 | 2.0/63 |
Features:
1) Magnificent flow rate and lift, the core energy of water
circulating, 2~3m suction lift
2) Engineering plastic body, the pump can be effectively protected
under bad weather,long service life;
3) Seiko manufacturing, low noise during the pump working time;
4) Free-tool filter cover design, easy to maintenance;
5) IP55 protection level, with None-leaky design;
6) German technology IBC bearing, 100% copper wire motor, 24 hours
running.
7) Anti-rust cast-aluminum motor cover, fast heat dissipation; PPO
plastic steel material impeller, resist high temperature and
corrosion
8) Silicone sealing ring cover all watering section, enhance pump
sealing system
9) CE certificated, reliable and safety
Description:
INSTALLATION
Only qualified licensed electrician should install pump and wiring.
IMPORTANT ELECTRICAL
Electrical Contractors Please Note: All 220/380 Volt 50Hz pumps
must be wired to the main power
supply through an approved and correctly rated electrician.
PUMP MOUNT MUST
Ÿ Be solid Level Rigid Vibration Free.
Ÿ Allow use of short, direct suction pipe. (To reduce friction
losses & don’t install the pump more
than 3M geometrical height from water level)
Ÿ Allow for gate valves in suction and discharge piping.
Ÿ Have adequate floor drainage to prevent flooding.
Ÿ Be protected from excess moisture.
Ÿ All adequate access for servicing pump and piping.
NOTICE
Pump suction and discharge connections have moulded in thread
stops, DO NOT try to screw pipe
in beyond these stops.
OPERATION
NEVER run pump dry! Running pump dry may damage seals, causing
leakage and flooding! Fill
pump with water before starting motor.
Before removing lid:
STOP PUMP before proceeding.
CLOSE GATE VALVES in suction and discharge pipes.
RELEASE ALL PRESSURE from pump and piping system.
NEVER tighten or loosen screw while pump is operation.
PERFORMANCE: This Pool Pump takes care of cleaning, filtration and
chlorine/salt distribution. features a removable strainer basket
with a built-in thermal overload protection as the water circulates
and passes through the filter leaves your pool clean.
Factory Introduction
FREESEA group has been engaged in pool filtration industry for more
than 15 years. Mainly produce pool filtration equipment: Sand
filter, circulation pump, vaccum air blower, etc. It is located in
Ningbo city Zhoushan island, we provide OEM service for many famous
pool brand in foreign & domestic market. Pumps annual output more
than 20 thousands. We accept different standard(USA, EU, CN
etc).Has many branches in China main city and Spain, sales network
extend to all over the world.
